[s-cars] can someone quickly verify or answer this flywheel question?

[Steve Eiche]

James,
The timing pin is located 62 degrees BTDC.  No, it will not align with the reference senser.  I did a quick check, and found that the timing pin is 35.5 ring gear teeth (~100 degrees by eyeball) from the -0- mark on my stock 3B flywheel.  A measurement showed 196mm on a direct line from pin to mark.

HTH!

Steve




>>How far from the -0- mark on the flywheel should the reference pin be on a 
>>3b or AAN ECU equiped car?
>  
>

Or more importantly, If the car is at TDC #1 cylinder and the mark on the 
flywheel through the window reads -0-, should the pin on the flywheel align 
with the reference sender unit if I pulled the sender out?

James