spacers -- Re: [s-cars] "New" Eibach Springs

[Tony]

No, I believe they were specifically made for the Bilstein shocks - 50mm
diameter. But call ECS Tuning to check.

Tony
96 S6

----- Original Message -----
From: "Bill Clancy" <clancybill at yahoo.com>
To: <Djdawson2 at aol.com>; <tony.curran at sympatico.ca>;
<S-CAR-List at audifans.com>
Sent: Sunday, May 23, 2004 8:38 AM
Subject: spacers -- Re: [s-cars] "New" Eibach Springs


> Speaking of baseball...
>
> will these spacers work on any spring/shock combo?     I like my new
Intrax
> springs but the are just a tad too low.   The web site indicated a drop of
> 1.5 inches front, 1.3 rear.   I think it's closer to 1.75 all around.
> It's not that big of a deal (yes it is...I'm a perfectionist).
>
> Can spacers be put in the front as well as the rear?
>
> ----- Original Message -----
> From: <Djdawson2 at aol.com>
> To: <tony.curran at sympatico.ca>; <S-CAR-List at audifans.com>
> Sent: Saturday, May 22, 2004 10:57 PM
> Subject: Re: [s-cars] "New" Eibach Springs
>
>
> > In a message dated 5/22/04 3:07:47 PM Mountain Daylight Time,
> > tony.curran at sympatico.ca writes:
> > Looking for comments on the "new" Eibach 1529-140 springs that have been
> > re-released as made in USA. My local Eibach dealer said there was a
> mistake made
> > somewhere along the line in Europe that caused the rear to drop more
than
> the
> > front. I suspect the new springs will do the same so I've ordered some
> spacers
> > from ECS tuning
> >
> >
> >
> > Great springs.  I've put them in 2 local cars.  No spacers required...
> > repeat, NO SPACERS... and once more.... please don't use spacers!!!
> >
> > Good luck,
> > Dave in CO
> > PS:  No spacers are required.
> > _______________________________________________
> > S-CAR-List mailing list
> > S-CAR-List at audifans.com
> > http://www.audifans.com/mailman/listinfo/s-car-list
>