[s-cars] Xenon Lights Installation

[James Murray (QB/EMC)]

Depends on if you have seperate igniters from the ballasts.... usually those models have longer cables so you have more choice of mounting locations... I mounted mine in the side fenders behind the front indicators, looks really clean!

If you have combined igniters and ballasts then your leads are probably shorter and you'll have to attach them to either the front light housing or onto a bracket attached to the front light washers. Check out the write up on www.urs4.com and I'll try to find my old write up to send you.

Cheers, /James "back to lurk mode" Murray... 

-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com]On Behalf Of Sean Douglas
Sent: Wednesday, October 06, 2004 12:01 AM
To: s-car-list at audifans.com
Cc: NDoshi at aol.com
Subject: [s-cars] Xenon Lights Installation


I just picked up a set of OEM xenons from German ebay and have a few
questions. I'm pretty sure there are a few listers that have gone this
route (Igor, Nick D and Bob DG).

1. Where did you mount the ballasts, they come with a mounting bracket
attached and I haven't had a close look at the engine bay yet, but I'm
not sure where they mount up.

>From an old post by Nick:

>>Here is what I have accomplished so far:

The cabling for the lights is - Red (+12v unswitched), Brown - Earth,
Yellow 
(Low beam "ON"), Black - Sense Wire for Bulb Monitor circuit.>>

2. Where does the black sense wire tap into?

Thanks,

Sean Douglas
1997 Audi S6//RS2-spec
1990 Audi 90 quattro 20v

_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list