[s-cars] S6 IC Crossover Pipe

[Southerlin, Russell S]

I was wandering around under my car the other day (looking for a turbo leak) and
noticed that the IC crossover pipe is very "squashed" down from its inlet and outlet diameters.

I did some rough measurements of outer diameters of inlet/outlet and squashed down
area and figure that the squashed area is about 13% smaller than the inlet/outlet area.

Anyone ever tried to make a X-over pipe that maintained the inlet/outlet area and if so was there any noticeable gains?

I've got some ideas for fabricating a prototype but was just wondering if there are any BTDTs?

Does Samco make a aftermarket X-over pipe?

Russell Southerlin
95.5 S6