[s-cars] Headlight Washer Wiring

[Sean Douglas]

According to the diagram, the pump is fed via a white/red wire from the
headlight washer relay (J39). Maybe this relay is bad, I'd start there.

Since you don't have a Bentley, I posted 3.17 MB pdf file of the wiring
diagram on my ftp site. Its diagram #34.

You should be able to right click and save as;

http://www3.telus.net/thumbelina/Audi%20S6/audi.c4.wd.84.pdf

Hope this helps.


Sean Douglas
1997 Audi S6//RS2-spec
1990 Audi 90 quattro 20v


> -----Original Message-----
> From: s-car-list-bounces+quattro20v=telus.net at audifans.com 
> [mailto:s-car-list-bounces+quattro20v=telus.net at audifans.com] 
> On Behalf Of calvinlc at earthlink.net
> Sent: Saturday, October 16, 2004 2:48 PM
> To: s-car-list at audifans.com
> Subject: [s-cars] Headlight Washer Wiring
> 
> 
> Hey guys,
> 
> I have finally gotten around to trying to track down my 
> headlght washer problem and I have run into a dead end.
> 
> The pump itself works fine, verified with +12V.
> The wiring is not receiving 12V when I pull the stalk, yes 
> the headlights are on :)  I am wondering where the white wire 
> with the red stripe
> (positive) wire goes from the pump.  Is it fed by a fuse or 
> relay?  The ground wire seems to be intact (0 ohms resistance 
> to chassis) I don't have a Bentley so I am a bit lost at this 
> point.  Somehow the headlights and the stalk have to play 
> into it.  I do see a flicker on the meter when I pull the 
> stalk but then it just goes right back to a few millivolts.  Thanks!
> 
> --Calvin
> 
> 
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com 
> http://www.audifans.com/mailman/listinfo/s-> car-list
>