[s-cars] FW:

[Beer, Jerald S.]

I had this done on my 200q recently. It was a PITA. There is an arm that
goes through the steering column on my car to interlock the steering
wheel. Since the tab broke out of the back of the tumbler (the piece
that goes into the electrical connetor), I had to replace the tumbler.
To get the the tumbler out, the steering lock arm had to be rotated 90
degrees and there was not enough room. So the wheel had to come off, and
I believe the steering column dropped to allow the room to pivot the
tumbler with the steering cloumn interlock arm. Since your tumbler  is
already out, the problem will be on the install (don't you just love "to
install just r and r!) if the C4 chassis has the same setup. Check the
archives over the last 6 months or so. 
Regards,
Jerry
91 200qa
>  -----Original Message-----
> 
> 
> That I dont know, in the 5k (havent HAD to look at the S4 assembly
> yet) the lock assembly was bolted onto the column through an arm
> extension thing so it wouldn't come out with out doing some additional
> work. Not positive on this though, becaise as I said, never had to
> replace the whole thing, just the little end cap in the back that was
> held in with a small set screw.
> 
> -Nick
> 
> 
> On Fri, 18 Feb 2005 06:08:46 -0800 (PST), chris chambers
> <fastscirocco_2000 at yahoo.com> wrote:
> > Nick,
> > 
> > Thanks for the quick reply.
> > Do yuou have any idea why the "lock assembly" would come out on it's
> 
> > own? What do I have to do to fix that?
> > 
> > Evidently it's been coming out for the last few months.
> > 
> > Thanks again
> > Chris
> > 
> > --- Nick Stuart <baredok at gmail.com> wrote:
> > 
> > >