[s-cars] short shaft

[Mark Strangways]

You could sell it to me
----- Original Message ----- 
From: "Bill Mahoney" <wmahoney at disk.com>
To: <s-car-list at audifans.com>
Sent: Monday, February 28, 2005 1:01 PM
Subject: [s-cars] short shaft


> Folks
> Since the family went out of town for the weekend, I was able to:
> 1. Install new front rotors n pads.
> 2. Replace LR abs sensor.
> 3. New plugs 
> 4. Attempt to adjust HRSB for clearance.
> 5. Party Saturday night like itwas 1999.
> 
> WRT #4 Clearance of the springs just isn't in the cards for the sway
> bar.
> I took the bar off and spent hours fiddling with this. It needs to be
> about 30mm longer IME to clear the springs.  Perhaps moving the bar
> towards the rear of the car would provide clearance, but would require
> some major reengineering of the mounting brackets.  So, should I pursue
> the latest generation of HRSB (thinking these may be longer?) Or, weld a
> 30mm extension in the center of the shaft.  Or, cut the bar and join
> each half together with a 75 mm coupling/collar?  
> I'm just not engineer enough to figure this out.
> 
> TIA
> Bill short shaft M
> 
> 
> 
> 
> 
> 
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>