[s-cars] Afterrun relay? Thermoswitch..Rust in a trim?

[todnad at comcast.net]

I believe that's a 10 or 12 guage wire - best solution is solder & shrink wrap tube.  Put a shrink wrap tube on ; solder your ends together; put the shrink wrap tube in place & heat it up w/a heat gun.

-------------- Original message -------------- 

> Ok folks, sorry for confusion... 
> 
> My fault, after I replaced that corroded blue connector near IC - I used 
> cheap crimp connector from Radioshack. And of course it fried after couple 
> of weeks. So... Pump would run for a while until cool engine off enough 
> (without a fan) I noticed it when my AC started to shut off on stop lights 
> like it did before. 
> 
> What good solid connector should I get and where?? 
> 
> Thanks, 
> Ivan 
> 
> >From: Tom Green 
> 
> >is most likely the faulty part 
> >but I don't know why the fan isn't running also. This is a battery killer 
> >if this relay doesn't open 
> >after the 5 or 10 minute run time since the fan and pump will continue to 
> >run until power is exhausted. 
> 
> 
> _______________________________________________ 
> S-CAR-List mailing list 
> S-CAR-List at audifans.com 
> http://www.audifans.com/mailman/listinfo/s-car-list