[s-cars] Ball bearing turbo

[James Murray (QA/EMC)]

Dave, would using the 3071 require upgrading the head studs or possibly the pistons? The 3071 looks like it makes a lot power that the RS2 turbo... Then again I guess if you use RS2 software or similar and don't seek the limits of that turbo the engine should be fine?
 
I figured if Mark wants to stay in safer limits.. the GT28RS or GT2871RS would be comparable to the RS2 yet quicker response.
 
/Jamu.

-----Original Message-----
From: djdawson2 at aol.com [mailto:djdawson2 at aol.com]
Sent: Tuesday, October 18, 2005 11:48 AM
To: James Murray (QA/EMC); HAHNMGH at peoplepc.com; s-car-list at audifans.com
Subject: Re: [s-cars] Ball bearing turbo


 I would suggest the 3071.  Javad has it with the KKK hot side.  I ran it on my car for awhile using the .63 A/R turbine, and it hits as early as an RS2.  It has the benefit of being able to move about 44lbs/min efficiently, as opposed to only about 34lbs/min for the RS2.
Dave
 
-----Original Message-----
From: James Murray (QA/EMC) <james.murray at ericsson.com>
To: 'HAHNMGH at peoplepc.com' <HAHNMGH at peoplepc.com>; Audifans Audifans <s-car-list at audifans.com>
Sent: Tue, 18 Oct 2005 08:29:20 -0500
Subject: Re: [s-cars] Ball bearing turbo


Mark, take a look at the turbo's offered by  http://www.034efi.com/index.php?cPath=21 <http://www.034efi.com/index.php?cPath=21>  

The GT28RS sounds like what you are looking for...comparable to RS2, however you 

might want to consider the GT2871RS too.



I have not tried any of these myself, however if you are looking for ball 

bearing turbo's 034efi has a full line up for the I5 20V.



/Jamu.