[s-cars] Bilstein Sports Installed

[Mark Pollan]

Russ, et.al.:

Regarding the "Igor Offset", I too have a question on that specific area.
After extending the slot on the camber plates I am still at -1.3.  I need to
pull her apart and do the Igor mod but want to ensure that 4mm offset is
enough to get me in and around -0.50.  Given our geometry with
Bilstein/Eibach set-up, what does a 4mm move translate to in degrees?

If'n nobody knows, can someone perhaps illuminate just how I could make that
determination myself?

Regards,

Mark

-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com] On Behalf Of Southerlin, Russell S
Sent: Monday, September 19, 2005 11:50 AM
To: s-car-list at audifans.com
Subject: [s-cars] Bilstein Sports Installed

All,
Thanks for the help.

I got my car put back together last night although still need to do an
alignment. I am going to do a homebrew alignment to get it close. I am
using a set of those laser levels to shoot laser dot onto wall.  We will
see how it works. 

Anyway I still don't have enough camber adjustment on right side even
after doing the Igor 4mm offset - should have done 5 or 6 mm offset??
As far a drop I have right at 362mm rear and 368mm drivers front and
380mm pass front.   The front right is almost 0.5inch higher than front
left??  Not sure what is going on there.  It looks like I will need the
10mm spacer after all. Anyone know what could cause the front right to
be so high?

Russell Southerlin



_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list