[s-cars] Rear suspension question

[Alvin Labonite]

S-folks:

My passenger rear sits a tad lower than the opposite side. It's noticeable 
by sight and by measurement. I have eibachs right now and used to have H&Rs 
with the same issues. I followed the Bently procedure as far as sitting the 
springs on the lower perch on both sides. Bently says that the end of the 
lower coil where it meets the stopper on the perch should face towards the 
rear and I did this on both sides and yet, it's still uneven.

Do you think turning it around facing the front would make a difference? I 
doubt I have two uneven sets of springs. If I recall the stock setup then 
was even but too darn high. :)

I hope I am making sense here.

TIA

Alvin
95 Avant