[s-cars] New motor mounts

[chris chambers]

Sean,

My new motor mounts arrived Tuesday, I plan on replacing them
this weekend (If I can fix my jack).

There were two different part numbers for each mount, but they look
the same to my untrained eye.

Did yo notice anything different between the two mounts?
I assume you lifted your car up and put it onjack stands right?

Thanks
Chris

--- Sean Douglas <quattro20v at telus.net> wrote:

> Installed both engine mounts today, not too hard, took me about 3
> hours
> including wrestling with the belly pan.
> 
> Driver side, easy.
> 
> The turbo side one is not that hard to get out, a long extension with
> a
> u-joint on the end and you can reach down between the turbo and
> exhaust
> manifold to get the top bolt. A socket will not reach the bottom
> nuts,
> so a combo wrench is used. It would be easier with a gear wrench.
> 
> Make sure to support the engine with a floor jack under the oil pan.
> 
> Hint, after removing the hardware, jack up on the engine to lift it
> as
> high as will go, this will give you more clearance to maneuver the
> mounts out.
> 
> Shifting has improved, still not as tight as I want and the trans
> mounts
> were done about 2 months ago.
> 
> Looks like a new snub mount is on the horizon.
> 
> Sean Douglas
> 
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
> 


Make April 15th just another day http://www.fairtax.org


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com