[s-cars] Engine Speed and Ignition Signal Sensor Location figure

[Eric Phillips]

Hmm.  The link says the engine won't run unless G28 is operational. 
Yet when I had the codes pulled before I bought the car, one of the
codes indicated a malfunctioning engine speed sensor.  Something is
funny here.

Especially considering my odd cruise control behavior.

Thanks for the picture and link.  I'll have to dig deeper, I guess.

No UrS content follow, but it is Audi...

I changed a stuck-open thermostat in my '90 80q.  What a Charlie
Foxtrot.  Dumped G11 everywhere (accident with drain pan.)

Figured out I had to move an accessory pump half-way through.

Had to demolish the old thermostat to get it out.

Spent three hours doing a half-hour job.  And Pizzo wasn't even "helping" me.

Finally, I'm looking for the bleed screw.  Nowhere to be seen.  The
Bentley has a nice diagram of it.  Nope, can't find it.  Is there an
alternate location?  Oh, yeah - now I'm running one quater G11 and
three quarters water.  Crap.

On 3/19/06, Dave Forgie <forgied at ae.ca> wrote:
> Eric:  Just yesterday I posted a figure and a link to info about the engine
> speed sensor and ignition signal sensor on AudiWorld.
>
> http://forums.audiworld.com/s4s6/msgs/112039.phtml
>
> The drawing also shows the oil pressure sensor and switch location and
>  the after-run pump location.