[s-cars] J-Hose fix upcoming...

jpb3 jpburns3 at gmail.com
Wed May 10 17:22:26 EDT 2006


Eric,

I have # N-904-054-01 as the part # for the crush washers on the J hoser.  I
just did a visual on the j hose I am sending out for repair and they look a
tad smaller than what is on there now.  Can anyone on the list verify the #
above for the correct crush washer (rubber) for the J hose?

Thanks,

John


On 5/9/06, Eric Phillips <gcmschemist at gmail.com> wrote:
>
> Thanks for the info, and yes, I would indeed like the part numbers.
>
> Thanks!
>
> Eric
>
> On 5/9/06, jpb3 <jpburns3 at gmail.com> wrote:
> >
> > Hi Eric,
> >
> > You will need to source new crush washers for tyhe re-install.  Dealer
> only
> > part, I have the # at home so if you reply and remind me I can send you
> > those tonight.
> >
> > Blau has undertray fastener kits...not too expensive and worth it.
> >
> > John
> >
> >
> > On 5/8/06, Eric Phillips <gcmschemist at gmail.com> wrote:
> > >
> > Oh, yes - the J-hose, she ist kaput.  Leaking pretty good, nice pool
> > o' Pentosin on my undertray.  I noticed the thing has banjo bolts -
> > when I send this to Spokane House o' Hose, do they ship me back crush
> > washers with that?  Or do I need to source those?  (The "where" of the
> > source would be good, LOL.  Thanks.)
> >
> > Kinda funny - I was fooling around with my new Stratmosphere BPV, and
> > dropped it, and it went right through to the tray.  Found the tray
> > missing some hardware, and haven't got a line on *that*, either.  Does
> > anyone sell undertray screw-type  hardware?  Anyway, once I was under
> > there, I noticed fluids.  Hmm, not good.  I guess when I put on my
> > FMIC, I'll be doing a j-hose r&r.  Anyone special I should talk to at
> > SHOH?
> >
> > Any neato screens in lines I should clean while I've got the lines
> > loose?  I'm going to change the fluid, and add a fin&tube PS cooler in
> > the place of the stock IC, so I'm hoping that any wisdom that exists
> > could be imparted.  :)
> >
> > Finally, there seems to be a bit of confusion on my part - the springs
> > on the '92 S4 do actually lower the subsequent models?  S-cars.org
> > says yes - about 3/4"  But supposedly EKTA says they're all the same
> > part no.  I would like to know before I go out and buy exact replicas
> > for my springs, when really what I want is the stiffer, shorter '92
> > springs.
> >
> > Thanks,
> >
> > Eric
> > _______________________________________________
> > S-CAR-List mailing list
> > S-CAR-List at audifans.com
> > http://www.audifans.com/mailman/listinfo/s-car-list
> >
> >
>
>
> --
> Eric
>
> 1995 UrS6 "Silber Geist"
>


More information about the S-CAR-List mailing list