[s-cars] Second hand advice

[Ian Duff]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA256

No rubber mallet needed, just two more fastenings to remove. Two of  
the threaded holes that receive the coil cover bolts must be removed.  
Can't remember if it's the middle or front and rear, but two of them  
are hex on the outside, and the other two are round with reinforcing  
webs cast in. The two hex ones come out. HTH.
- -Ian Duff.


On  21 Oct 2006, at 1:34:44PM, Robert Myers wrote:

>
> Hey Guys,
>
> I've been asked for advice and I'm (once again) clueless.  Can anyone
> give me something to send to Martin?  Please.
>
> TIA, Bob
>
> Here's the request:
>
> Hello Robert,
>
>    I was hoping that you could give me some advice on valve cover
> gasket replacement for my 95' s6 audi. I have taken the four bolts
> off the top and removed the coils and also removed the six screws
> that hold the valve cover gasket down. Are there more screws that I
> am not seeing because I cannot get it to budge. I have read that some
> people recommend using a rubber mallet to remove the cover. Any  
> suggestions?
>
> Martin
>
>
>
>
> Bob
> urS6 with RS2 and other mods for sale: http://chips-ur-s.com/S6.html
>
>
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>


-----BEGIN PGP SIGNATURE-----
Version: PGP Desktop 9.5.0 (Build 1112)
Charset: US-ASCII

wsBVAwUBRTqLrwbfJQrv0DtCAQhYzQgAnlfRYiie4MlXt+aS3te/FbfmGOzSSahk
ig3bp25GHqJFOEg3S2QUOcNto5NHDxbtLfaXbszC6rN7Q1w1rSfzkPsYcm9vaWX/
rYSnucoaZ2SJOYPPHukCWY1Rl+cK6btz11djxxkEi4YiGTdDfWQnLzXP/h1obW5o
xOlqw69WCk6G4z0CHXooBA0/rhG9pIY+Q9pclgd5ijMrE5+UcWzYnhuLRTF9Vu9a
3irejngoVSOZKzPqAQ5BWJ3eXuMgtyUOmg8oczYSdUsw6uTX5FnlsGo8/S6Qd8Fy
+TXU0VlHYG4HmDQKjOJcyhTcUvkplyls0OQnUNauBfziKxeShuy0IA==
=EBVM
-----END PGP SIGNATURE-----