[s-cars] Valves or rings or both

calvinlc at earthlink.net calvinlc at earthlink.net
Thu Aug 2 21:37:43 EDT 2007


Did you do the compression test with the car warmed up?
--Calvin


-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com]On Behalf Of Vincent Frégeac
Sent: Thursday, August 02, 2007 7:10 PM
To: s-car-list at audifans.com
Subject: [s-cars] Valves or rings or both


Hi,



After some part swapping, the S-Bitch finally gave her last word : The hot
start problem I’ve had for a few month is simply a way too low compression.
There’s apparently only 1 piston above 150 psi, the lowest one reading 70
psi dry, but I think the gauge is not that accurate! As I’ve been almost
only driving in heavy traffic during the last 12 month, it was hard to
notice the lack of power I could not use anyway.



Remembering the numerous mechanical adventures I shared with the S-Bitch, I
think this may be related to a bad head rebuild 3 years ago.



When I tested the compression, wet and dry, the compression was 10-20 psi
better with oil in the cylinder which tends to say valves and cylinders
leaking. But I’ve read in a few places that a leaking cylinder ring will
burn oil and the S-Bitch burn less than a ¼ quart between oil changes. So,
can I expect just a head rebuild – may be worth it – or should I prepare for
a full rebuild – which will probably means the S-Bitch will be parted out
instead.







Vincent.

_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list



More information about the S-CAR-List mailing list