[s-cars] Clutch pedal won't come back out
QSHIPQ at aol.com
QSHIPQ at aol.com
Thu Jun 28 13:01:16 EDT 2007
If the clutch works when you push it in, but it won't come out, it's more
likely the master. Lift it with your toe until you get home. Yes, this is a
known issue. Bleeding it might help, you can do this as a roadside repair,
btdt. The slave bleed screw is 11mm wrench (some replacement aftermarkets were
8mm some were 7mm). Push the pedal down leave it at the floor and open the
bleeder screw, this should cause a steady drain of fluid from the slave
bleeder. After you get new fluid out of it, close the bleeder screw, and pump the
pedal about 30 times. Then crack the bleeder again, and you should get a
little air burp, do this until there is no air when you crack the bleeder.
This should help you get to where you can do the R&R.
HTH
Scott Justusson
In a message dated 6/27/2007 9:09:28 P.M. Central Daylight Time,
tr0910 at gmail.com writes:
Clutch has started misbehaving. Push the clutch into the floor, and it
stays there. Won't come back out. Finally figured out if your pull it back
out with your toe, that it heals itself.
Is this a known issue?
Tim
93 S4 170K (clutch replaced at 90K)
************************************** See what's free at http://www.aol.com.
More information about the S-CAR-List
mailing list