[s-cars] Off with the drive shaft (Mark Turczyn)

[Kurt Deschler]

> I dead blow hammered the front one to break it free from the gasket.
>
> Too bad I cannot just drop it down from the tranny in the front and
> try to re-grease or remove it in place.
>
> I cannot seem to pull it back far enough for the center shaft to
> clear the lip of the tranny prop shaft.
>
> Anyone know if this can be done and I am not getting full stroke due
> to the dry grease????

I was able to remove and service the driveshaft CVs on my 200 this way. I 
recall prying slightly on the driveshaft to push it back far enough. 
However, removing the center is much easier and the rust will show you 
where to put it back on. You could also try shooting in some grease with a 
grease needle and see if it quiets down before removing completely.


 	-Kurt