[s-cars] Off with the drive shaft (Mark Turczyn)

[Mark Turczyn]

>
>I was able to remove and service the driveshaft CVs on my 200 this way. I
>recall prying slightly on the driveshaft to push it back far enough.
>However, removing the center is much easier and the rust will show you
>where to put it back on. You could also try shooting in some grease with a
>grease needle and see if it quiets down before removing completely.
>
>  	-Kurt


Kurt-

Chris also said it could be done--- when I can I will go under and 
try to gently pry it down and see if I can clear the tranny.  Then 
either re-grease or if needed, try to remove in place.

Thanks
-- 
Mark Turczyn