[s-cars] Motor Mount Torques

Douglas Fifield douglas.fifield at gmail.com
Fri Nov 16 09:27:10 PST 2007


I decided to bag the motor mounts.  I unbolted the top nuts and
loosened the front snub mount and gently jacked the engine up.  It
cleared the stud on the drivers side, but not the passenger.  Plus,
the engine moved forward so that I had to push the drivers side stud
back to get the engine to lower back down.

Damn,  I was just not comfortable putting any more force on the engine.

D.

On Nov 16, 2007 10:37 AM, Mark Pollan <mark.pollan at verizonbusiness.com> wrote:
> I too could not find anything other than the generic torque specs.  The 2.8
> V6 section does however specify 33 ft lbs for the engine mounts so I think
> you should feel comfortable with using 33 Douglas.
>
> Mark
>
>
> -----Original Message-----
> From: s-car-list-bounces at audifans.com
> [mailto:s-car-list-bounces at audifans.com] On Behalf Of Douglas Fifield
> Sent: Friday, November 16, 2007 11:06 AM
> To: S List
> Subject: [s-cars] Motor Mount Torques
>
> Anyone have specific torque settings for the motor mount nuts on an AAN?
>
> I don't see anything in the Bentley other than the generic M10 torque
> of 45 Nm (33 ft lb).
>
> Beuller?
>
> --
> Douglas in MN
> 95.5 Audi S//6 Avant
> 73 BMW R60/5 mit Toaster Tank
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>
>
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>



-- 
Douglas in MN
95.5 Audi S//6 Avant
73 BMW R60/5 mit Toaster Tank


More information about the S-CAR-List mailing list