[s-cars] Valve Cover Gasket Question
brian hoeft
qweblog at gmail.com
Wed Nov 28 16:12:19 PST 2007
eh, might take a few weeks off its lifespan.. oh, and after thinking about
it, 800 grit would speed things up and isnt overly abraisive,, just dont
go too hard.
On 11/27/07, Douglas Fifield <douglas.fifield at gmail.com> wrote:
>
> I can pull the cover back off and wipe things down. Will brake
> cleaner harm the gasket itself do you think?
>
> On Nov 26, 2007 9:33 PM, brian hoeft <qweblog at gmail.com> wrote:
> > Id say it really has to do with how its deformed. roll the dice.
> luckily
> > its not hard to re re-do the job.. This is why it is suggested by some
> to
> > place gasket maker(thinly) goo around corners and trouble spots.
> >
> > Presuming you dont have any air tools you could put a buffer wheel on
> and
> > clean up, you could get by with 1000 grit wet-sand paper. Other than
> that,,
> > maybe a little brake/carb cleaner on a rag. Elbow grease!
> >
> > remember, you can fold the sandpaper to get into grooves.
> >
> >
> >
> > On 11/26/07, Douglas Fifield <douglas.fifield at gmail.com> wrote:
> > >
> > >
> > >
> > > Hedz,
> > >
> > > As part of my recent R&R project, I replaced the valve cover gasket on
> > > my AAN. It didn't seem to fit perfectly and I wasn't sure it sat
> > > correctly all around. I was correct in that I see a wet spot on the
> > > front, passenger side corner.
> > >
> > > So, my question is, can the cover be removed, the gasket repositioned
> > > and reused (assuming it was not pinched or otherwise damaged)?
> > >
> > > Second question is, how does one properly clean the mating surfaces of
> > > oil prior to laying down the gasket? If I wanted to use a little RTV
> > > to help the gasket stick at awkward points (like the corners), the
> > > surfaces need to be clean as per directions on the sealant. So I
> > > would need to degrease the valve cover and the gasket prior to putting
> > > down a thin film of sealant.
> > >
> > > Thanks for your help and advice.
> > >
> > > D.
> > >
> > > --
> > > Douglas in MN
> > > 95.5 Audi S//6 Avant
> > > 73 BMW R60/5 mit Toaster Tank
> > > _______________________________________________
> > > S-CAR-List mailing list
> > > S-CAR-List at audifans.com
> > > http://www.audifans.com/mailman/listinfo/s-car-list
> > >
> >
> >
> >
> > --
> > ====
> > ! beat the NWO cult ! www.RonPaul2008.com || and be proud of my allies
> at
> > >> www.hourofthetime.com
> >
> > //brian
>
>
>
> --
> Douglas in MN
> 95.5 Audi S//6 Avant
> 73 BMW R60/5 mit Toaster Tank
>
--
====
! beat the NWO cult ! www.RonPaul2008.com || and be proud of my allies at
>> www.hourofthetime.com
//brian
More information about the S-CAR-List
mailing list