[s-cars] Tap size needed for waste gate screw?
Young, Steve
sryoung at trane.com
Tue Jun 17 17:30:06 PDT 2008
Dave...
I was able to remove the screw from my "butchered" cap. According to my
thread gauge, the screw is an M12x1.25. Good luck.
Regards,
Steven Young
Local Operations Manager - Albany
____________________________________TRANE
301 Old Niskayuna Rd., Latham, NY 12110
Tel: 518.724.1453
Fax: 518.785.4359
www.trane.com
The information in this message is the property of TRANE. This message
is intended only for the use of the addressee named above and may
contain legally privileged and/or confidential information. If you are
not the intended recipient of this message, you are hereby notified that
any use, dissemination, distribution or copying of this message is
strictly prohibited. If you receive this message in error, please
notify us immediately by telephone or return e-mail and delete the
message, all copies thereof and any attachments. We thank you for your
cooperation.
-----Original Message-----
From: Dave Ellis [mailto:UrS4 at sympatico.ca]
Sent: Tuesday, June 17, 2008 1:13 PM
To: Young, Steve
Subject: Re: [s-cars] Tap size needed for waste gate screw?
Not sure. I tried exerting *some* force to back it out more, but the
screw jammed firmly. I'm a little afraid to exert too much force for
fear of breaking something.
Dave
Young, Steve wrote:
> Dave...
>
> The screw is steel and the cap is aluminum. Will backing out the
> screw clean up the threads?
>
>
> Regards,
>
> Steven Young
> Local Operations Manager - Albany
> ____________________________________TRANE
> 301 Old Niskayuna Rd., Latham, NY 12110
> Tel: 518.724.1453
> Fax: 518.785.4359
>
> www.trane.com
>
> The information in this message is the property of TRANE. This message
> is intended only for the use of the addressee named above and may
> contain legally privileged and/or confidential information. If you
> are not the intended recipient of this message, you are hereby
> notified that any use, dissemination, distribution or copying of this
> message is strictly prohibited. If you receive this message in error,
> please notify us immediately by telephone or return e-mail and delete
> the message, all copies thereof and any attachments. We thank you for
> your cooperation.
>
>
> -----Original Message-----
> From: s-car-list-bounces at audifans.com
> [mailto:s-car-list-bounces at audifans.com] On Behalf Of Dave Ellis
> Sent: Tuesday, June 17, 2008 8:36 AM
> To: s-car-list
> Subject: [s-cars] Tap size needed for waste gate screw?
>
>
> Went to back off the wastegate screw yesterday and noticed that the
> top threads are damaged, likely from whenever the cover plate was
> drilled off.
>
> Does anyone know the size of tap needed to to re-tap the waste gate?
>
> Thanks!
>
> Dave
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>
More information about the S-CAR-List
mailing list