[s-cars] Tap size needed for waste gate screw?

[Dave Ellis]

Thanks Steve!

Dave



Young, Steve wrote:
>  
> Dave...
> 
> I was able to remove the screw from my "butchered" cap.  According to my
> thread gauge, the screw is an M12x1.25.  Good luck.
> 
> Regards,
> 
> Steven Young
> Local Operations Manager - Albany
> ____________________________________TRANE
> 301 Old Niskayuna Rd., Latham, NY  12110
> Tel: 518.724.1453
> Fax: 518.785.4359
> 
> www.trane.com
> 
> The information in this message is the property of TRANE. This message
> is intended only for the use of the addressee named above and may
> contain legally privileged and/or confidential information.  If you are
> not the intended recipient of this message, you are hereby notified that
> any use, dissemination, distribution or copying of this message is
> strictly prohibited.  If you receive this message in error, please
> notify us immediately by telephone or return e-mail and delete the
> message, all copies thereof and any attachments. We thank you for your
> cooperation.
> 
> 
> -----Original Message-----
> From: Dave Ellis [mailto:UrS4 at sympatico.ca] 
> Sent: Tuesday, June 17, 2008 1:13 PM
> To: Young, Steve
> Subject: Re: [s-cars] Tap size needed for waste gate screw?
> 
> 
> Not sure.  I tried exerting *some* force to back it out more, but the
> screw jammed firmly.  I'm a little afraid to exert too much force for
> fear of breaking something.
> 
> Dave
> 
> 
> Young, Steve wrote:
>> Dave...
>>
>> The screw is steel and the cap is aluminum.  Will backing out the 
>> screw clean up the threads?
>>
>>
>> Regards,
>>
>> Steven Young
>> Local Operations Manager - Albany
>> ____________________________________TRANE
>> 301 Old Niskayuna Rd., Latham, NY  12110
>> Tel: 518.724.1453
>> Fax: 518.785.4359
>>
>> www.trane.com
>>
>> The information in this message is the property of TRANE. This message
> 
>> is intended only for the use of the addressee named above and may 
>> contain legally privileged and/or confidential information.  If you 
>> are not the intended recipient of this message, you are hereby 
>> notified that any use, dissemination, distribution or copying of this 
>> message is strictly prohibited.  If you receive this message in error,
> 
>> please notify us immediately by telephone or return e-mail and delete 
>> the message, all copies thereof and any attachments. We thank you for 
>> your cooperation.
>>
>>
>> -----Original Message-----
>> From: s-car-list-bounces at audifans.com
>> [mailto:s-car-list-bounces at audifans.com] On Behalf Of Dave Ellis
>> Sent: Tuesday, June 17, 2008 8:36 AM
>> To: s-car-list
>> Subject: [s-cars] Tap size needed for waste gate screw?
>>
>>
>> Went to back off the wastegate screw yesterday and noticed that the 
>> top threads are damaged, likely from whenever the cover plate was 
>> drilled off.
>>
>> Does anyone know the size of tap needed to to re-tap the waste gate?
>>
>> Thanks!
>>
>> Dave
>> _______________________________________________
>> S-CAR-List mailing list
>> S-CAR-List at audifans.com
>> http://www.audifans.com/mailman/listinfo/s-car-list
>>
>