[s-cars] Wheel Bearing tool?

Sean Douglas s_douglas at telus.net
Thu May 8 10:50:12 PDT 2008


Dave:

Is this the front or rear?

You can take out the wheel bearing housing and use a hydraulic press to
re-re. The front is harder as the strut and housing is all one piece. The
rear is a little easier as its separate.

I did all 4 of mine at once when I had my suspension apart.

I don't know how much a shop would charge, but I'd figure they would charge
a flat rate to recover their tool rental.

Sean 

> -----Original Message-----
> From: s-car-list-bounces at audifans.com 
> [mailto:s-car-list-bounces at audifans.com] On Behalf Of Dave Kase
> Sent: May 8, 2008 10:40 AM
> To: S-Cars
> Subject: [s-cars] Wheel Bearing tool?
> 
> So the Audi tool is $400+
> 
> Are there any alternatives?  I am not into making one unless 
> it is drawn up already.
> 
> Or should I just suck it up and take it to the shop?  What's 
> the going rate to R&R a wheel bearing?
> 
> Dave Kase
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
> 




More information about the S-CAR-List mailing list