[s-cars] Wheel Bearing tool?

[Mark Pollan]

I have said Schley tool I bought back in the early 90's.  It has a variety
of "washers" and "cups" made of hardened steel.  These are used to pull out
and press in your bearings using a mongo nut and bolt.  It works quite well
and the nice thing about it is that you do not have to remove the strut
housing to perform bearing work.  I'd be pleased to share for the cost of
shipping but understand that it weighs quite a bit.  But if you are
willing...

Regards,

Mark

-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com] On Behalf Of Dave Kase
Sent: Friday, May 09, 2008 9:33 AM
To: Tom Green
Cc: s-car-list
Subject: Re: [s-cars] Wheel Bearing tool?

I think it is just a Hub Shark type tool but made just for Audi/VW.

It is here. 
<http://www.fap99.com/item.wws?sku=VWW038532&itempk=3390&mfr=Schley%20Tools&
weight=15.62&cookieID=2CE0MMJX22D60KD9H6&clientid=fap99>

Dave



Tom Green wrote:
> What is this $400 Audi tool, Dave?
>
> I would appreciate any information you have on it's description and
> what it does.  The only things I know about are the dies for use in a
> hydraulic press and clamshell for holding the axle stub.  I expect a set
> of these could cost $400.
>
> Tom
>
>> Date: Thu, 08 May 2008 13:40:19 -0400
>> From: Dave Kase <davekase at pdqlocks.com>
>> Subject: [s-cars] Wheel Bearing tool?
>> To: S-Cars <s-car-list at audifans.com>
>> Message-ID: <48233B03.2000902 at pdqlocks.com>
>> Content-Type: text/plain; charset=ISO-8859-1; format=flowed
>>
>> So the Audi tool is $400+
>>
>> Are there any alternatives?  I am not into making one unless it is drawn
>> up already.
>>
>> Or should I just suck it up and take it to the shop?  What's the going
>> rate to R&R a wheel bearing?
>>
>> Dave Kase
>
_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list