[s-cars] Wheel Bearing tool?

Tom Green trgreen at comcast.net
Fri May 9 06:58:59 PDT 2008


James,

I guess I am a little slow, but I can't figure out how to remove the  
axle
hub with this tool, or how it can be used until the hub is out of the  
way.
And then, how to get the hub back in the bearing, all this while the  
strut
is still on the vehicle.

This tool sounds like a great time saver. Can you help with a few hints?

Tom

> Date: Thu, 08 May 2008 12:16:29 -0600
> From: James Shackelford <93urs4 at rovershack.com>
> Subject: Re: [s-cars] Wheel Bearing tool?
> To: Dave Kase <davekase at pdqlocks.com>, S-Cars
> 	<s-car-list at audifans.com>
> Message-ID: <C4489F9D.11C9%93urs4 at rovershack.com>
> Content-Type: text/plain;	charset="US-ASCII"
>
>
> Dave,
>
> Get the hub shark knock-off from Harbor Freight.  It worked like a  
> charm on
> my wheel bearings.... I think it's about $60-70.  Handy tool to add  
> to the
> collection.
>
> James
>
> On 5/8/08 11:40 AM, "Dave Kase" <davekase at pdqlocks.com> wrote:
>
>> So the Audi tool is $400+
>>
>> Are there any alternatives?  I am not into making one unless it is  
>> drawn
>> up already.
>>
>> Or should I just suck it up and take it to the shop?  What's the  
>> going
>> rate to R&R a wheel bearing?
>>
>> Dave Kase



More information about the S-CAR-List mailing list