[s-cars] S6A+ hatch and wiring
Tom Green
trgreen at comcast.net
Wed Jun 3 14:49:17 PDT 2009
>
I have participated in two group buys by europrice which means at least
10 for each buy and several avants-several previous GB's also.
The avant center section shown in european photos has an opening for
the handle instead of the license plate lighting diffuser. All those
sold
here had the solid clear diffuser that interferes with the handle. I
would
not cut the plastic section since I think it reinforces the piece.
Instead the answer is to cut the horizontal section of the handle off,
leaving
only the vertical portion protruding down from the lock opening with the
boot around it. The handle is a little more stealthy for someone not
in the
know, but it works great. Baloney claims to have dremeled his off in
situ,
but if you are refurbishing the interior panels and have them removed,
it is
a simple process to remove the handle and cut it off.
I like Audi's genuine sealant cord for a sure seal on the lights and
even use
some pieces for attaching the license plate instead of bolts. I also
trimmed
the license plate slightly to better fit the euro plate section--fake
plastic bolt
heads in sealing cord to complete the look.
Tom
> Jack Walker wrote:
> At the same time I'm replacing the Avant's rear hatch light bar -
> reflector
> with a European S6A+
>
> Has anyone done this before?
>
> Are there two versions of the S6+, an Avant and Sedan? I got this from
> Europrice and he said there isn't when I got it like forever ago!
>
> The US version doesn't cross over from each side on the license
> plate, it's
> totally open across the top of the trim piece that the license plate
> attaches too
>
> The hatch lift latch handle doesn't seem to fit under the cross
> piece from
> each side on the S6+
>
> Has everyone simply cut it out all the way across where the latch
> handle
> piece fits up to it, this is possible but I'm thinking not too smart!
>
>
>
> I've also got a Euro S6 hatch cover/reflector/lights that's in three
> pieces
> the two reflectors and the center license plate holder with the
> exact same
> problem!
More information about the S-CAR-List
mailing list