[s-cars] 1.8T Coil Pack question

[chris chambers]

Tony,

Yes to allow the coil to fully seat you need to trim the rubber boot. 

The UrS4/UrS6 forum on Quattroworld has an excellent FAQ here:
http://forums.quattroworld.com/s4s6/msgs/15184.phtml

On it is a complete write up on the 1.8t coil conversion, here is the link:
http://www.s-cars.org/postnuke/downloads/pdf/18tCoilPackConversionInstructions.pdf

And in that PDF file there is a photo of a modified and unmodified coil, should be helpful.


HTH
Chris

 
----- Original Message ----
> From: Tony Curran <tony.curran at sympatico.ca>
> To: S-CAR list <s-car-list at audifans.com>
> Sent: Mon, April 5, 2010 9:00:49 PM
> Subject: [s-cars] 1.8T Coil Pack question
> 
> Hi all,



I'm investigating a hi boost mis and was about to go 
> replacing the coils one
at a time (I have the Apikol ignition set) when I 
> noticed the spare I carry
is slightly different to those installed - came 
> with the kit. I bought a 06B
905 115R from local stealer. This coil has a 
> rubber bung at the top end that
the originals don't have.



Do 
> I have the wrong coil or do I have to strip this bung off?


> 

TIA.



Tony

96 
> S6

_______________________________________________
S-CAR-List mailing 
> list
http://audifans.com/mailman/listinfo/s-car-list
http://www.audifans.com/kb/List_information