[s-cars] Clutch slave dilemma

Wylie Bean theringmeister at triad.rr.com
Mon Feb 14 18:38:54 PST 2011


Yup, had forgotten about that Scott... there's a notch in the side of the trans that the slave sits in and it holds it in place while you put the bolt in. 

Wylie Bean
TheRingmeister at triad.rr.com
90 cq
91 90q20v
92 UrS4
08 Q7 3.6
via BlackBerry®

-----Original Message-----
From: qshipq at aol.com
Sender: s-car-list-bounces at audifans.com
Date: Mon, 14 Feb 2011 21:31:01 
To: <mplatt911 at yahoo.com>; <s.b.mills at gmail.com>
Cc: <s-car-list at audifans.com>
Subject: Re: [s-cars] Clutch slave dilemma


 It's bolted in with a 8mm (13mm wrench) bolt.  It's not easy to get up there without driveshaft/heat shield removal, but it certainly can be done on the car, on the ground.  Loosen the line first, then go at the retaining bolt.  There is a recess where the bolt hole is lined up, if it's not aligned you can strip the threads in the trans, btst.

HTH

Scott J

 


 

 

-----Original Message-----
From: Mike Platt <mplatt911 at yahoo.com>
To: Steve Mills <s.b.mills at gmail.com>
Cc: s-car-list at audifans.com
Sent: Mon, Feb 14, 2011 6:31 pm
Subject: Re: [s-cars] Clutch slave dilemma


thanks for all the replies folks! Still need to know how to change the slave ON 

THE CAR.
>...

 
_______________________________________________
S-CAR-List mailing list
http://audifans.com/mailman/listinfo/s-car-list
http://www.audifans.com/kb/List_information


More information about the S-CAR-List mailing list