[s-cars] Bright headlight switch question - 95 S6 Avant
LL - NY
larrycleung at gmail.com
Sat Jan 22 15:13:40 PST 2011
Held off replying just in case there was a fix for the headlight switch. I
had to replace the combo switch due to a failed wiper switch. And spray
contact cleaner did nothing to restore wiper function when the switch
failed, it pretty well did something similar to Tom's high beam switch, I
could get partial function by holding the switch in a between detent
position. TG for Rain-X. The replacment procedure for the wiper/turn signal
lever on my 200Q, is straightforward. The biggest issue is following the
procedures to disarm the airbag exactly, or a code will be thrown. There is
a connector in the center console that must be pulled first and reconnected
last before removing the airbag/steering wheel assembly. The problem is I
can't recall what the connector looks like, but I'm sure it'll be in the
FAQ's. Just letting Y'all know it's not a difficult procedure.
On Sat, Jan 22, 2011 at 4:33 PM, Tom Green <trgreen at comcast.net> wrote:
> Tom,
>
> There have been some reports of electrical contact cleaner sprayed in
> the crevices without disassembly of the steering have restored
> function, but I hold little confidence in the practice. Replacement
> stalk for the headlights will get you new turn signal lever and cruise
> control along with the on-off/flash switch. It requires removal of
> the air bag and steering wheel for access, but then is simple R/R.
> The genuine Audi part is priced close to the aftermarket switches, so
> genuinevwaudiparts.com, bimmerparts.com or autohausaz.com had best
> prices last check I made.
>
> The FAQ on Quattroworld is sure to have some DIY hints for the
> procedure, or steering wheel removal at least.
>
> Tom
>
> On Friday January 21, 2011, at 06:28AM, Tom Winters<
> tom at tomwintermedia.com
> >wrote:
>
> > Guys, I may have to replace this switch (located on the steering
> > column) or
> > at the very least remove and clean.
> >
> > Brights can no longer be activate with the stalk, but the "pull to
> > flash"
> > function still works fine. All other functions are fine. . Turn
> > signals etc.
> >
> > Problem is definitely the stalk as I was able to wiggle stalk to
> > activate
> > the brights once or twice prior to complete failure.
> >
> > Any been there done that advice?
> >
> > Thanks in advance.
> >
> > Tom '95 S6 Avant
>
> _______________________________________________
> S-CAR-List mailing list
> http://audifans.com/mailman/listinfo/s-car-list
> http://www.audifans.com/kb/List_information
>
More information about the S-CAR-List
mailing list