[s-cars] New fuel filter won't stop leaking

[tr0910]

My new filter already had a fitting attached to the upper end where it
attached to the fuel line with a beveled connection (no banjo here).  There
was already a copper washer between this fitting and the fuel filter (no
leaks here).  This is where the second large copper washer would go,
correct?  The end where the banjo is is where I used 2 of the 4 washers
(here is where the leak is).  Steel one on the bolt end, and a copper one
between the banjo and the filter.  This leaves one steel washer extra with
no place to go, or in my case, since I didn't need to move the fitting from
the upper end of the old filter, I ended up with an extra steel and an extra
copper.

thanks for the assistance
Tim

On Tue, Jun 7, 2011 at 8:19 AM, Martin Kozaczek <mkozaczek at gmail.com> wrote:

> One side of the filter should have a larger size opening than the other,
> the two larger washers go there.  The other side will get the two smaller
> washers.  Both sides get one between the banjo and bolt and one between the
> banjo and filter housing.
>
> Good luck!
>
>
>