[s-cars] Wiring question

[Erik Addy]

Thanks... I do have the manual, and wired it up like this:
http://forums.quattroworld.com/s4s6/msgs/97718.phtml
 
When it didn't work, I went back and double checked my connections and found a bad ground.  Now it works, except for a problem where if I lock it with the remote, and then use the key to open the door, the alarm goes off when I turn on the ignition.
 
Now I can't recall if I tapped anything into the gn/bl wire.  I think however, that my problem may be with the oe system, not the rightclick install.
Since I have had the car, the central locking has ONLY worked from the door switches, NOT by using the drivers door key or trunk key.  Makes me think something is wrong or disconnected somewhere so the oe system does not get the signal that you opened the door/trunk with the key.  Any ideas on that anyone?  If I can't figure it out, I will just try to wire the system so that it locks/unlocks but doesn't arm the alarm (using the instructions you just gave me).  Then I just need to wire up the trunk release and I am done.
 
Thanks!
 

>________________________________
>From: Tony Curran <tony.curran at sympatico.ca>
>To: 'Erik Addy' <erikaddy at yahoo.com>; s-car-list at audifans.com
>Sent: Saturday, October 29, 2011 9:39 PM
>Subject: RE: [s-cars] Wiring question
>
>Errik,
>
>I did a little while ago. The wire you want is the gn/bl wire on pin 5 of
>the central locking pump under the passenger seat. Snip the gn/bl wire then
>wire Orange/black and white wire either side of the snip.
>
>Do you have the instructions?
>
>Cheers,
>
>Tony
>96 S6
>
>-----Original Message-----
>From: s-car-list-bounces at audifans.com
>[mailto:s-car-list-bounces at audifans.com] On Behalf Of Erik Addy
>Sent: October-28-11 6:26 PM
>To: s-car-list at audifans.com
>Subject: [s-cars] Wiring question
>
>Well, I just tried to look this up on my Bentley CD-ROM and discovered that
>Bentley does not support Windows 7.  Nice.  Perhaps I should get a 486 with
>Windows 95 to go along with my 1994 Audi...
> 
>Anyway, I am trying to wire in one of those RightClick keyless entry systems
>on my '94 S4.  I wired it up the normal way, and it isn't working (well, I
>didn't use a relay, but I can't get it to lock or unlock, so I'm not sure
>that is the problem).
> 
>I need to do some more checks, but I was hypothesizing that it might not
>work because my alarm doesn't work (I know the PO had a problem with this, I
>think they just disconnected something).  However, the door switch for
>lock/unlock works, so there should be some way for me to just get the
>RightClick unit to simulate to the pump the same input as the door switch. 
>Anyone know what color wires the door switch uses, and perhaps where they
>connect to the pump (which plug)?
> 
>Thanks
>Erik
>_______________________________________________
>S-CAR-List mailing list
>http://audifans.com/mailman/listinfo/s-car-list
>http://www.audifans.com/kb/List_information
>
>
>
>