[s-cars] Door Latch Repair or Replace?

[Tony Curran]

Hi Jack,

You can see the attachment point for this rod on illustration 870-00, just
next to item 16 (the clip). I have the same problem. The rod that I have
floating around has a broken metal piece still attached with the clip still
plugged in to it. A cylinder mechanism from a parted car may not last as it
is as old or older than your own - I'm in same position. So I'm seriously
considering the new cylinder part number 4A0 837 063 D from stealer - mine
is charging me $211 for the part.

Good luck,
Tony

-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com] On Behalf Of Jack Walker
Sent: December-10-13 4:09 PM
To: s-car-list at audifans.com
Subject: Re: [s-cars] Door Latch Repair or Replace?

I have an S6 that the rod from the interior door release to the door
mechanism at the rear end of the door has disconnected, I'll be damned if I
can even feel anything inside the front or sides of the mech that feels like
a rod would attach to??

I've seen the EKTA that shows the rod going forward,  but not the attachment
points where the rod attaches. Anybody have any advice??

 

> Looking for a S6 that is being parted out. Actually I require the

> driver door lock mechanism as mine suffered a failure in the cold

> weather we had here recently. One of the inner door locking rods (4A0

> 837 195 B) is floating freely with a broken piece attached to it which

> may be part of the cylinder though not sure where it attached to. 

> There are three rods. One attaches to the door handle, one to the knob

> and the third which appears it could attach to the cylinder.

 

_______________________________________________
S-CAR-List mailing list
http://audifans.com/mailman/listinfo/s-car-list
http://www.audifans.com/kb/List_information