[s-cars] 1995.5 S6 Avant window assembly

[vittorio at mybares.com]

Thanks for the tips - picked up an entire assembly from Chris at F5 - installed last night.
 
It'll go through the car wash today, we'll see if any changes need to be made to the alignment - but I doubt it, seemed pretty tight.
 
I'll keep the motor and glass from the old window just in case.
 
--------- Original Message --------- Subject: Re: [s-cars] 1995.5 S6 Avant window assembly
From: "Airbil Gmail" <airbil at gmail.com>
Date: 3/3/14 12:37 pm
To: "s-car-list at audifans.com" <s-car-list at audifans.com>, "Vittorio.Bares at nuance.com" <Vittorio.Bares at nuance.com>

Vittorio,
 Best solution IMVHO is to get a new one ... $170ish at GAP. This window gets a lotta use and a used one may fail poste haste.
 Remove interior door panel. IIRC there are only four large bolts holding the window and regulator. Take care to see the window shim between the frames on the lower forward bolt. 
 When reassembling, push the shim up as far as you can, pull the top of the window frame inward as far as you can and then tighten the bolt/s.(no wind noise strategy)
 If you haven't done this b4, take a lotta pix so you know where the foam pieces go.
 This all can be done in an hour, or three... depending.
 Good luck!
 Bill~S-CarList Lives!~m
 
 
 
 ~ via airmobil 1 ~
 _______________________________________________
 S-CAR-List mailing list
 http://audifans.com/mailman/listinfo/s-car-list
 http://www.audifans.com/kb/List_information