[s-cars] intermittent ABS pulsing through pedal at complete stop

Jim Fleischer jim at almgt.com
Wed Jun 22 11:46:56 PDT 2016


Thanks all for the ideas….I am traveling for the next week or so and won’t get a chance to check all of this out until I return later this month.  FWIW, the car is a ’95 and I don’t have a VAG-COM yet, so I’ll just need to do things the old-fashioned way….one connector at a time.

One thing of note…. I have been driving my GF’s 2004 Allroad 6MT a bunch for the last month or so while figuring out my steering rack mount woes, and I will say that I just love the feel of the urS6 so much better…. On every level it seems like the better car for my tastes and has convinced me to continue to fix the car to get it back to DD duty….thanks all for the help in making that happen!

Best regards,

Jim Fleischer
’95 urS6 avant
195K



From: Tom Green
Sent: Friday, June 17, 2016 1:41 PM
To: s-car-list at audifans.com; jim at almgt.com
Subject: Re: [s-cars] intermittent ABS pulsing through pedal at complete stop

Ian has you pointed right on target to check the wheel sensor.  Which one? Since you messed with both axles maybe even front and back?  Is that avant a 121 series vehicle known around here as a 95.5 model?  If so, you might get more with a scan for DTCs, especially if you use a VAG-COM (even Lite version) to scan for any codes.  The latest vehicles can even cough up the offending wheel. If it is more than just a sensor needing adjustment, you should also have a caution/warning light.  Maybe the welder disconnected the cable to the drivers front wheel when doing the bracket repair?

It is even simpler than this if you just have someone outside the vehicle standing close to the side of the vehicle as you brake to a stop (in your driveway perhaps).  The observer should easily pick out the wheel that is pulsing the brake caliper.

You did remove and clean these sensors when you were changing the CV boots, didn’t you?  Don’t answer that.

Tom

> On Jun 17, 2016, at 3:00 PM,Jim Fleischer <jim at almgt.com> wrote:
> 
> Hey all,
> 
> As I get my car back on the road after the Steering Rack bracket saga (so far so good with new fabricated piece welded in on the frame support under rack) I am uncovering some additional issues.  I replaced each outer CV joint boot within the last couple of days, and noticed recently that I am getting ABS feedback from the brake pedal sometimes when coming to a complete stop….essentially at the end of the braking episode I’ll feel a little vibration through the pedal.  Not every time, about 40-50% of the time.  Going forward and backing up.  No dash lights (brake or ABS) just the pulsing.  No other braking issues, firm pedal and solid stopping power.  Any clues?
> 
> Thanks!
> 
> Jim Fleischer
> ’95 urS6 avant, slowly coming back to life!
> 195K






More information about the S-CAR-List mailing list