[urq] Head, manifold and downpipe removal - update

[Alan Pemberton]

Thanks for the responses.  I finally cut off the final bolt at the lower end
of the concertina from below and the downpipe is now off, the head on the
bench and the manifold removed.

Alan

85 urq (Canadian)



----- Original Message ----- 
From: "Thatcher Hubbard" <thatcher.hubbard at gmail.com>
To: <urq at audifans.com>
Sent: Friday, November 12, 2004 2:00 PM
Subject: Re: [urq] Head, manifold and downpipe removal


> Not that getting the nuts off of the turbo->downpipe connection is
> necessarily easy either.  The furthest nut back was a big pain.  And
> it came out with the stud, but hey, what can you do?
>
> Is the flexible metal portion really cheap?  I'd heard that it was
expensive.
>
> The bolts at the WG->EM flange should be relatively easy to get to
> from the top of the car and not so bad from the bottom if you've
> removed the axle heat shield.  I used a 3/8" drive with a copule of
> long extensions on it at the bottom and a box-end wrench on the top.
> I would strongly suggest putting some effort into breaking those
> loose.  Of course, they may be rounded out, rusted off nubs at this
> point, in which case I'm completely full of it.  The bolts that
> connected my downpipe to my muffler were that way, replaced at some
> point with SAE ones by the PO.  I had to saw halfway through all three
> of them with a hacksaw blade I'd wrapped the end of with duct tape,
> then break them by twisting each end in the opposite direction.  Not
> fun.
>
>
> On Fri, 12 Nov 2004 13:32:54 -0800, Justin <cbrooks2 at san.rr.com> wrote:
> > Yep, your right....that's the best way....get the nuts off the
> > turbo...(remove the air box if nessary...) and then remove the nuts off
that
> > flexiable connector pipe ("concertina hose")
> > from the EM to the downpipe.
> >
> > I think Alan's concertina hose bolts are frozen though...
> >
> > Another way is just to cut the concertina hose with a saw-zal (they are
> > cheap to replace...and get from a yard...) by accessing it through the
wheel
> > well.  (Had to do this recently...)
> > Justin C.
> >
> >
> >
> >
> > ----- Original Message -----
> > From: "Thatcher Hubbard" <thatcher.hubbard at gmail.com>
> > To: <urq at audifans.com>
> > Sent: Friday, November 12, 2004 6:28 AM
> > Subject: Re: [urq] Head, manifold and downpipe removal
> >
> > > When I took mine apart I had to remove the downpipe as well.  Is it
> > > possible to get the wastegate separated from the EM and the DP
> > > separated from the turbo?  I think both of those can be done by one
> > > set of hands.
> > >
> > > I suggest that because removing the axle would probably not be a lot
of
> > fun.
> > >
> > >
> > > On Fri, 12 Nov 2004 01:00:38 -0800, Justin <cbrooks2 at san.rr.com>
wrote:
> > > > If you can't get the downpipe off...then, the only way to get the
entire
> > > > assembly off, is to remove the axle.
> > > >
> > > > as I've tried...(on my many junk yard head removal trips..)
> > > > to get the downpipe and head past the axle.....
> > > > Justin
> > > >
> > > >
> > > >
> > > > ----- Original Message -----
> > > > From: "Alan Pemberton" <alan_pemberton at telus.net>
> > > > To: <urq at audifans.com>
> > > > Sent: Thursday, November 11, 2004 6:55 PM
> > > > Subject: [urq] Head, manifold and downpipe removal
> > > >
> > > > > I am in the process of removing the head, exhaust manifold, turbo
and
> > > > > downpipe as one assembly - number 2 cylinder manifold gasket has
blown
> > as
> > > > > one stud had sheared and the other is loose.
> > > > >
> > > > > Working alone, but with a temporary hoist arrangement, I've been
> > unable to
> > > > > remove the complete assembly as a unit and have only been
successful
> > > > > removing one of the nuts associated with the concertina hose so
cannot
> > > > > separate the downpipe.  The removal problem is working the
downpipe
> > around
> > > > > the drive shaft.  The heat deflector has been removed but it looks
> > like I
> > > > > need to remove the driveshaft.  The front of the car is on ramps.
> > > > >
> > > > > Is removing the drive shaft the next step or have I missed
something?
> > > > >
> > > > > Alan
> > > > > '85 urq (Canadian)
> > > > >
> > > > >
> > > > >
> > > > >
> > > > >
> > > > > _______________________________________________
> > > > > Audifans urq mailing list
> > > > > Send posts to: mailto:urq at audifans.com
> > > > > Manage your list connection:
> > http://www.audifans.com/mailman/listinfo/urq
> > > > > Have an urq question?  Check the Audifans Knowledgebase!
> > > > > http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> > > > > Have an urq answer? ... Please help others by adding to the KB ...
all
> > > > contributions welcome!
> > > >
> > > > _______________________________________________
> > > > Audifans urq mailing list
> > > > Send posts to: mailto:urq at audifans.com
> > > > Manage your list connection:
> > http://www.audifans.com/mailman/listinfo/urq
> > > > Have an urq question?  Check the Audifans Knowledgebase!
> > > > http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> > > > Have an urq answer? ... Please help others by adding to the KB ...
all
> > contributions welcome!
> > > >
> > > _______________________________________________
> >
> >
> > > Audifans urq mailing list
> > > Send posts to: mailto:urq at audifans.com
> > > Manage your list connection:
http://www.audifans.com/mailman/listinfo/urq
> > > Have an urq question?  Check the Audifans Knowledgebase!
> > > http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> > > Have an urq answer? ... Please help others by adding to the KB ... all
> > contributions welcome!
> >
> > _______________________________________________
> > Audifans urq mailing list
> > Send posts to: mailto:urq at audifans.com
> > Manage your list connection:
http://www.audifans.com/mailman/listinfo/urq
> > Have an urq question?  Check the Audifans Knowledgebase!
> > http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> > Have an urq answer? ... Please help others by adding to the KB ... all
contributions welcome!
> >
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all
contributions welcome!
>