[urq] Barrel crimper?

[Bill Bennett]

VAG courtesy of Alldata



CAUTION!


  a.. All wiring harness and connector repairs must only be performed using 
repair kit VAS 1978!
  b.. Before beginning wiring and connector repairs, determine and rectify 
the cause of damage, eg.: pinched between metal parts, malfunctioning 
electrical consumers, corrosion due to water ingress etc.
  c.. Soldering is NOT permitted to any vehicle wiring.
  d.. Do not repair welded connections in wiring harnesses. If necessary, 
fabricate overlay wiring harness.
  e.. All shielded wiring (eg.: knock sensors, repair etc.) are Not to be 
repaired! Replace complete wiring harnesses as necessary.
  f.. When repairing airbag and seat belt tensioner wiring harnesses, use 
only prescribed terminals, connectors and wiring.
----- Original Message ----- 
From: "j.koenig" <j.koenig at adelphia.net>
To: "Bill Bennett" <ur.quattro at verizon.net>
Sent: Saturday, August 20, 2005 6:27 AM
Subject: Re: [urq] Barrel crimper?


> Bill, would you mind being a little more specific.  I'm not doubting 
> you -- just curious.
> Exactly where in the literature do you find this?
>
> John
>
>
> ----- Original Message ----- 
> From: "Bill Bennett" <ur.quattro at verizon.net>
>
>
> YOH W.! Here is a quote from VAG Service literature
> a.. Soldering is NOT permitted to any vehicle wiring.  seems very consice 
> to
> me,   do you understand it? or do you need clarification? Billy Ray Bob
>
>