[urq] Anybody know what the thread size is on the halfshaft?

[Jim Haseltine]

Top of the strut piston rod? M14x1.5 and it's very hard stuff - or should 
be.

Regards,

Jim Haseltine

----- Original Message ----- 
From: "eric harten" <audi90sq at yahoo.com>
To: "urq" <urq at audifans.com>
Sent: Sunday, February 20, 2005 3:18 PM
Subject: [urq] Anybody know what the thread size is on the halfshaft?


>I have the suspension off the UrQ this winter (doing coil-overs) and 
>noticed
> one of the spindle nuts was hard to get off.  Turns out the threads on the 
> end
> of the shaft were a bit rough.  I want to run a tap over them before I put 
> the
> spindle nut back on.  Does anyone know what the thread size is?  Thanks
>
> Eric Harten
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all 
> contributions welcome!
>