[urq] Anybody know what the thread size is on the halfshaft?

[Bill Bennett]

eric harten wrote:

>I have the suspension off the UrQ this winter (doing coil-overs) and noticed
>one of the spindle nuts was hard to get off.  Turns out the threads on the end
>of the shaft were a bit rough.  I want to run a tap over them before I put the
>spindle nut back on.  Does anyone know what the thread size is?  Thanks
>
>Eric Harten
>_______________________________________________
>Audifans urq mailing list
>Send posts to: mailto:urq at audifans.com
>Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
>Have an urq question?  Check the Audifans Knowledgebase!
>http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
>Have an urq answer? ... Please help others by adding to the KB ... all contributions welcome!
>
>__________ NOD32 1.1003 (20050219) Information __________
>
>This message was checked by NOD32 antivirus system.
>http://www.nod32.com
>
>
>
>  
>
Save your money Eric, use a metric thread file, the pitch you want to 
use is 1.5, don't waste your coconuts buying a die. taps are for holes, 
dies are for male threads