[urq] valve housing / bleeder valve

[Jim Haseltine]

A hole in that hose will make the fuel mixture lean. Engine will not run 
very well, may even stall at low revs.

Regards,

Jim Haseltine

----- Original Message ----- 
From: "Johan H" <milisen at hotmail.com>
To: <urq at audifans.com>
Sent: Thursday, July 21, 2005 9:49 AM
Subject: [urq] valve housing / bleeder valve


> Hi guys,
>
> I ran into a few problems with my -88 urq yesterday. On the valve housing 
> is the breather hose. From this hose there is a t-junction made out of 
> rubber (shown on ETKA illustration 4-00), this hose had a hole in it. Do 
> you have any clues of how this will affect the engine?
>
> The other problem was the injection cooler: when should this switch on?
>
> Cheers,
> Johan Hisinger
> Helsinki, Finland
>
> _________________________________________________________________
> Auktioner: Tjäna en hacka på gamla prylar http://tradera.msn.se
>
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all 
> contributions welcome!
>