[urq] E-brake cable dust boot

[Buchholz, Steven]

Yes, I've BTDT long ago ... 

I just made it work from inside the car ... if you can't seem to reach
through the hole to grab the boot you can pull the rod it is on off the
e-brake mechanism and pull it into the cabin far enough to access the
dangling boot.  

I don't recall this one being that difficult to seat on the rim ... ISTR
the similar boot on the shift linkage was a bit more difficult.  If you
have problems getting the rim in the boot to engage the seam you may
want to pull the entire lip of the boot into the cabin (i.e. pull in the
first fold or two of the accordion section, and then carefully wok the
boot around the edge of the seam.  

Steve B
San Jose, CA (USA)
> 
> Any BTDT's?
> 
> I need to figure out a way to seat the dust boot for
> the emergency brake cable where it passes out of the
> vehicle along the center tunnel - without having to
> remove the drive shaft. It's not exactly easy to get
> at from inside the vehicle or underneath.
> 
> Any suggestions would be greatly appreciated.