[urq] Clutch slave cylinder retaining pin-removal?

[Buchholz, Steven]

... no ridicule from this camp ... sounds pretty much the same as what I
do.  The only thing to be careful of is to make sure you've got the
correct Allen bit ... my first attempt I used one I thought was the
right one, but it almost wedged inside the roll pin!  Sorry, I don't
have the size for you ... and, I used an SAE size ... as I rarely have
call for them in the intended use ... ;-)

Steve B
San Jose, CA (USA)
> 
> At the risk of being ridiculed, I use a set of very long 1/2-inch
> socket extension bars with a "correctly" sized allen head socket
> extension on the tranny end. I drive the pin out from the end reaching
> through a wheel well.