[urq] Clutch slave cylinder retaining pin-removal?

[Bill Bennett]

sounds like a great solution Andrew, the others ain't bad either, even if 
you use the wrong size and get it stuck inside the stoopid roll pin you 
could lever it out with side cutters and go up a size, damn fine solution.
   Best, Bill
----- Original Message ----- 
From: "Andrew Finney" <afinn1 at gmail.com>
To: <urquattro at comcast.net>
Cc: <urq at audifans.com>
Sent: Monday, May 09, 2005 1:28 PM
Subject: [urq] Clutch slave cylinder retaining pin-removal?


At the risk of being ridiculed, I use a set of very long 1/2-inch
socket extension bars with a "correctly" sized allen head socket
extension on the tranny end. I drive the pin out from the end reaching
through a wheel well.

Andrew Finney
1983 UrQ.
_______________________________________________
Audifans urq mailing list
Send posts to: mailto:urq at audifans.com
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
Have an urq question?  Check the Audifans Knowledgebase!
http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
Have an urq answer? ... Please help others by adding to the KB ... all 
contributions welcome!