[urq] Hi Pressure PS hose

[Tom Saltino]

Brandon,

I removed mine last week with an impact, a swivel, and a 24mm socket.  It
was pretty tight.  I ran the air line through the left wheel well where the
tie rod runs.

BTW, my rubber bushings were trashed too!

Tom

-----Original Message-----
From: urq-bounces at audifans.com [mailto:urq-bounces at audifans.com] On Behalf
Of Brandon Rogers
Sent: Monday, November 14, 2005 3:04 PM
To: Urq List
Subject: [urq] Hi Pressure PS hose

Guys-
I'm trying to replace the high pressure hose (from Pump to Bomb) and am
struggling with the 24mm banjo bolt on the Bomb side.  

The bomb moves around quite a bit on the rubber cushions- I've stuck a few
big thick washers in between the two plates to keep it from squishing down,
and I've tried using a really big pair channel locks to keep the other side
from rising - to no avail.  Ben suggested I remove the bomb for more access
- I will try this - any other ideas?  Air tools? - have yet to try an impact
wrench but with the tie rod it may be too tight anyway...

TIA

Brandon 
'84 ur
_______________________________________________
Audifans urq mailing list
Send posts to: mailto:urq at audifans.com
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
Have an urq question?  Check the Audifans Knowledgebase!
http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
Have an urq answer? ... Please help others by adding to the KB ... all
contributions welcome!