[urq] Hi Pressure PS hose

[Martin Pajak]

You can also remove the isolators and mount the hydraulic manifold directly to the motor mount bracket (BTDT).
This makes the whole thing a lot more stable so you can tighten all the fasteners.  I don't remember if more than one bolt will line up though.. 

Cheers
Martin Pajak

http://www.quattro.ca

1982 Audi Ur-quattro (50,000 mi) new project
1985 Audi Ur-quattro (203,000 km) Euro spec. import mit 3B ;o) 
1987 Audi 4000s quattro (195,000 km) winter car 

---------- Original Message ----------------------------------
From: "Brandon Rogers" <brogers at terrix.com>
Reply-To: Brandon Rogers <brogers at terrix.com>
Date:  Mon, 14 Nov 2005 13:04:14 -0700

>Guys-
>I'm trying to replace the high pressure hose (from Pump to Bomb) and am struggling with the 24mm banjo bolt on the Bomb side.  
>
>The bomb moves around quite a bit on the rubber cushions- I've stuck a few big thick washers in between the two plates to keep it from squishing down, and I've tried using a really big pair channel locks to keep the other side from rising - to no avail.  Ben suggested I remove the bomb for more access - I will try this - any other ideas?  Air tools? - have yet to try an impact wrench but with the tie rod it may be too tight anyway...
>
>TIA
>
>Brandon 
>'84 ur
>_______________________________________________
>Audifans urq mailing list
>Send posts to: mailto:urq at audifans.com
>Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
>Have an urq question?  Check the Audifans Knowledgebase!
>http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
>Have an urq answer? ... Please help others by adding to the KB ... all contributions welcome!
>