[urq] Fasteners for Dialynx EM

[Justin]

So what is everybody's opinion on the performance increase over the stock
EM?
thanx,
Justin C.
----- Original Message -----
From: "Bill Bennett" <ur.quattro at verizon.net>
To: "daniel dornseif" <skwpilot at yahoo.com>; <urq at audifans.com>
Sent: Sunday, October 09, 2005 8:27 PM
Subject: Re: [urq] Fasteners for Dialynx EM


> our Powder Coated EM from Brooks Performance came with specific
instructions
> to idle the car for two hours before driving so we did, VERY noticeable
low
> end improvement by Mr.Butt Dyno, and reliability? time will tell, the
> retorque after driving yielded no movement, that would indicate
reliability,
> most pleased with powder coating applied by a control freak, Daniel Brooks
> won't answer the phone while working
> ----- Original Message -----
> From: "daniel dornseif" <skwpilot at yahoo.com>
> To: <urq at audifans.com>
> Sent: Sunday, October 09, 2005 12:19 AM
> Subject: [urq] Fasteners for Dialynx EM
>
>
> >I have heard that they tend to warp slightly when they are heat cycled
for
> >the first time.  My Dialynx was used when I got it, and sure enough the
#5
> >port was out by about .5 to 1.0mm depending on where I measured.  My
> >recommendation is to heat cycle it (if it is brand new) and then check it
> >and have it machined if it warped.  It should be super after that IMHO.
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam?  Yahoo! Mail has the best spam protection around
> > http://mail.yahoo.com
> > _______________________________________________
> > Audifans urq mailing list
> > Send posts to: mailto:urq at audifans.com
> > Manage your list connection:
http://www.audifans.com/mailman/listinfo/urq
> > Have an urq question?  Check the Audifans Knowledgebase!
> > http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
> > Have an urq answer? ... Please help others by adding to the KB ... all
> > contributions welcome!
>
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all
contributions welcome!