[urq] Fasteners for Dialynx EM

[Bill Bennett]

our Powder Coated EM from Brooks Performance came with specific instructions 
to idle the car for two hours before driving so we did, VERY noticeable low 
end improvement by Mr.Butt Dyno, and reliability? time will tell, the 
retorque after driving yielded no movement, that would indicate reliability, 
most pleased with powder coating applied by a control freak, Daniel Brooks 
won't answer the phone while working
----- Original Message ----- 
From: "daniel dornseif" <skwpilot at yahoo.com>
To: <urq at audifans.com>
Sent: Sunday, October 09, 2005 12:19 AM
Subject: [urq] Fasteners for Dialynx EM


>I have heard that they tend to warp slightly when they are heat cycled for 
>the first time.  My Dialynx was used when I got it, and sure enough the #5 
>port was out by about .5 to 1.0mm depending on where I measured.  My 
>recommendation is to heat cycle it (if it is brand new) and then check it 
>and have it machined if it warped.  It should be super after that IMHO.
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all 
> contributions welcome!