[urq] Fasteners for Dialynx EM

[daniel dornseif]

I have heard that they tend to warp slightly when they are heat cycled for the first time.  My Dialynx was used when I got it, and sure enough the #5 port was out by about .5 to 1.0mm depending on where I measured.  My recommendation is to heat cycle it (if it is brand new) and then check it and have it machined if it warped.  It should be super after that IMHO.  

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com