[urq] down-pipe removal

[spot.ontheroad]

Dennis
Bear in mind my car is a WR so therefore vaguely similar - I lost a lot of 
skin trying to get mine out with out removing any major bits. In the end I 
removed the inlet manifold. Much easier this way and would have saved loads 
of time if I had done it this way to start with. I took DP out to fit an O2 
sensor where there previously hadn't been one (not needed on a WR) so as to 
run an air/fuel meter.
Good luck.

All the best

Keith

'87 WR


----- Original Message ----- 
From: <DGraber460 at aol.com>
To: <urq at audifans.com>
Sent: Sunday, September 25, 2005 6:03 PM
Subject: [urq] down-pipe removal


> Does anyone remember for certain if the down-pipe will snake out the 
> bottom
> of a 10V WX car with both manifolds in place?
> I'm trying to remove mine to replace the O2 sensor which is frozen. I have
> it totally disconnected but cannot see how it will come out the bottom or 
> top
> with other components in place.
> I also want to replace the downpipe as the PO welded an aftermarket CAT to
> it, and I want to use my OE system.
>
> Dennis
> Denver
>
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all 
> contributions welcome!
>