[urq] What have I done?!!

[n-engelbert at terrans.net]

> I've got one of those Fidanza AL flywheels mounted in my 016 with a stock
> urQ clutch and a urS pressure plate installed in my car.  I'm also using
> the stock urQ starter.  Everything went together without a hitch, but when
> I energize the starter it doesn't engage the flywheel.
>
> I've already checked the solenoid and it appears to be functioning
> correctly.  I'm wondering if the starter gear is extending far enough?  Do
> I need to use an UrS4 starter?  Or should I just throw the stock urQ
> flywheel back in the car??
>
> Anybody have any suggestions as to what could be going on inside my
> bellhousing??
>
> Thanks,
>
> Tom

Tom,

Are you sure you bought the correct flywheel?  The standard audi flywheel
that fidanza sells is for the 01A cars, and needs modification for 016
cars.  See here: 
http://www.motorgeek.com/phpBB2/viewtopic.php?t=1320&highlight=016+aluminum+flywheel

Starters between both cars should be the same, I think.  I thought all 5
cylinder starters would interchange.

Good Luck!

Nathan Engelbert
83 UrQ DA900453
89 90q
91 200q20v avant

Also, I've still got your seal driver, I'll get it in the mail tomorrow.